Struct simics_api_sys::step_cycle_ratio_t

#[repr(C)]
pub struct step_cycle_ratio_t {
    pub steps: uint32,
    pub cycles: uint32,
}

The step_cycle_ratio interface is implemented by processors that support a changeable ratio between steps and cycles. The set-step-rate command uses this interface to set the ratio between steps and cycles.

The set_ratio sets the ratio between steps and cycles. Note that the introduction of stall cycles can skew the ratio. The get_ratio simply returns the current ratio.

The cycles and step arguments must be in the range [1..128] and cycles must be a power of two. Implementers of this interface may choose to ignore other values of cycles and step and may log an error.

Cell Context for all methods.

Fields

steps: uint32

cycles: uint32

Trait Implementations

impl Clone for step_cycle_ratio_t

fn clone(&self) -> step_cycle_ratio_t

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for step_cycle_ratio_t

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl Default for step_cycle_ratio_t

fn default() -> step_cycle_ratio_t

Returns the “default value” for a type.

impl Hash for step_cycle_ratio_t

fn hash<__H: Hasher>(&self, state: &mut __H)

Feeds this value into the given Hasher.

fn hash_slice<H>(data: &[Self], state: &mut H)

where H: Hasher, Self: Sized,

Feeds a slice of this type into the given Hasher.

impl Ord for step_cycle_ratio_t

fn cmp(&self, other: &step_cycle_ratio_t) -> Ordering

This method returns an Ordering between self and other.

fn max(self, other: Self) -> Self

where Self: Sized,

Compares and returns the maximum of two values.

fn min(self, other: Self) -> Self

where Self: Sized,

Compares and returns the minimum of two values.

fn clamp(self, min: Self, max: Self) -> Self

where Self: Sized + PartialOrd,

Restrict a value to a certain interval.

impl PartialEq for step_cycle_ratio_t

fn eq(&self, other: &step_cycle_ratio_t) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl PartialOrd for step_cycle_ratio_t

fn partial_cmp(&self, other: &step_cycle_ratio_t) -> Option<Ordering>

This method returns an ordering between self and other values if one exists.

fn lt(&self, other: &Rhs) -> bool

Tests less than (for self and other) and is used by the < operator.

fn le(&self, other: &Rhs) -> bool

Tests less than or equal to (for self and other) and is used by the <= operator.

fn gt(&self, other: &Rhs) -> bool

Tests greater than (for self and other) and is used by the > operator.

fn ge(&self, other: &Rhs) -> bool

Tests greater than or equal to (for self and other) and is used by the >= operator.

impl Copy for step_cycle_ratio_t

impl Eq for step_cycle_ratio_t

impl StructuralPartialEq for step_cycle_ratio_t